SYSTEM DESCRIPTION
This DTC is stored when there is a malfunction in the certification ECU (smart key ECU assembly) battery power supply circuit or ground circuit.
DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
---|---|---|---|---|
B228B | System Voltage or GND Energization Malfunction | A malfunction is detected in the certification ECU (smart key ECU assembly) battery power supply circuit or ground circuit. (1-trip detection logic*) |
|
|
Vehicle Condition when Malfunction Detected | Fail-safe Function when Malfunction Detected |
---|---|
The engine stopped while driving. | - |
DTC No. | Data List and Active Test |
---|---|
B228B | - |
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Click here
HINT:
When the cable is disconnected and reconnected to the negative (-) battery terminal, the power source mode returns to the state it was in before the cable was disconnected.
PROCEDURE
1. | CHECK HARNESS AND CONNECTOR (POWER SOURCE) |
Click here
NG | REPAIR OR REPLACE HARNESS OR CONNECTOR IN CIRCUIT CONNECTED TO POWER SOURCE |
|
2. | CHECK HARNESS AND CONNECTOR (GROUND) |
Click here
OK | END (TEMPORARY CONNECTION FAILURE IS SUSPECTED) |
NG | REPAIR OR REPLACE HARNESS OR CONNECTOR IN CIRCUIT CONNECTED TO POWER SOURCE |
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Power Tilt And Power Telescopic Steering Column System: Telescopic Position Sensor or Telescopic Motor Circuit Malfunction (B2611)
DESCRIPTION The telescopic motor is operated by the power source voltage supplied from the multiplex tilt and telescopic ECU and slides the steering column forward and backward. The telescopic position sensor (Hall IC) in the telescopic motor detects the sliding position of the steering column in th ...
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Heated Oxygen Sensor: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during heated oxygen sensor removal/installation are shown below. Necessary Procedures After Parts Removed/Inst ...