Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual: Precaution

• Before disassembly, clean the outside of the differential assembly and remove any sand or mud to prevent it from entering the inside of the assembly during disassembly and installation.
• When removing an installed part made of light alloy such as the differential side bearing retainer, tap it off with a brass bar and a hammer. Do not attempt to pry it off with a screwdriver.
• Always arrange disassembled parts in order and protect them from dust.
• Before installation, thoroughly clean and dry each part and then apply Toyota Genuine Differential gear oil LT SAE 75W-85 GL-5 or equivalent to them. Do not use alkaline cleaner for aluminum or rubber parts and rear differential case bolts. Also, do not clean rubber parts such as oil seals with non-residue solvent.
• Coat sliding surfaces and rotating parts with Toyota Genuine Differential gear oil LT SAE 75W-85 GL-5 or equivalent.
• When holding a part in a vise, be sure to place aluminum plates between the part and vise. Do not put it directly in the vise.
• Always replace non-reusable parts with new ones.
• Do not damage the sealing surfaces of the case. Such damage may cause oil leakage.
• Before applying seal packing, completely remove any old seal packing remaining on the components using a non-residue solvent.
• Do not add oil within 1 hour or allow rapid acceleration or deceleration within 12 hours of installing sealed parts.
• Damage to surfaces in contact with an oil seal or gasket may cause oil leakage.
• When press-fitting an oil seal, do not damage the oil seal lip or outside periphery.
• When replacing a bearing, replace the inner and outer races as a set.
• When replacing a bearing, do not apply force to the roller or retainer.
• When replacing a hypoid gear, replace the ring gear and drive pinion as a set.
• New bearings are coated with anti-rust oil. If using new bearings, do not wash it off.
• If the threads or contact surface of a bolt is excessively rusty, replace the bolt.

Differential System

...

Problem Symptoms Table

PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of pr ...

Other materials:

Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Front Door Window Frame Moulding: Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. INSTALL FRONT DOOR FRONT WINDOW FRAME MOULDING (a) Using an air riveter or hand riveter with a nose piece, install the front door front wind ...

Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Sliding Roof System: Terminals Of Ecu
TERMINALS OF ECU CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) (a) Disconnect the U2 sliding roof ECU (sliding roof drive gear sub-assembly) connector. (b) Measure the resistance and voltage according to the value(s) in the table below. HINT: Measure the values on the wire harness s ...