MANUAL SHIFTING TEST
MANUAL SHIFTING TEST
HINT:
(a) Disconnect the transmission wire connector.
HINT:
It is possible to deactivate the electrical shift control by disconnecting the transmission wire. The gears can then be changed mechanically with the shift lever.
(b) Drive the vehicle with the transmission wire connector disconnected. Move the shift lever to each position to check whether the gear changes as shown in the table below.
| Shift Lever Position | Gear |
|---|---|
| P | P |
| R | R |
| D | 3rd No Shift (Gears will not change) |
(c) Connect the transmission wire connector.
(d) Clear the DTCs.
Click here
Hydraulic Test
RegistrationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Blind Spot Monitor System: System Description
SYSTEM DESCRIPTION GENERAL (a) The blind spot monitor system has a blind spot monitor function and RCTA function. (1) Blind spot monitor function
The blind spot monitor function is a function that assists the driver when changing lanes.
This function uses quasi-millimeter wave radar to detect veh ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Sfi System: Fuel Rail Pressure Sensor "A" Circuit Short to Battery or Open (P019015)
DESCRIPTION Refer to DTC P019011. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P019015 Fuel Rail Pressure Sensor "A" Circuit Short to Battery or Open The fuel pressure sensor (for high pressure side) output voltage is higher than 4.9 ...