INSTALLATION
PROCEDURE
1. INSTALL PURGE VALVE (PURGE VSV) (for TMMC Made)
(a) Install the purge valve (purge VSV) to the intake air surge tank assembly with the bolt. Torque: 21 N·m {214 kgf·cm, 15 ft·lbf} |
|
(b) Connect the No. 1 fuel vapor feed hose to the purge valve (purge VSV).
(c) Connect the fuel vapor feed hose to the purge valve (purge VSV) and slide the clip to secure it.
HINT:
Engage the clip within the area shown in the illustration.
(d) Connect the purge valve (purge VSV) connector.
2. INSTALL PURGE VALVE (PURGE VSV) (except TMMC Made)
(a) Install the purge valve (purge VSV) to the intake air surge tank assembly with the bolt. Torque: 21 N·m {214 kgf·cm, 15 ft·lbf} |
|
(b) Connect the No. 1 fuel vapor feed hose to the purge valve (purge VSV).
(c) Connect the fuel vapor feed hose to the purge valve (purge VSV) and slide the clip to secure it.
HINT:
Engage the clip within the area shown in the illustration.
(d) Connect the purge valve (purge VSV) connector.
3. INSTALL V-BANK COVER SUB-ASSEMBLY
Click here
Lexus RX (RX 350L, RX450h) 2016-2023 Repair Manual > Brake Fluid: On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT BRAKE FLUID LEVEL IN RESERVOIR (a) Check the fluid level. If the brake fluid level is lower than the MIN line, inspect for brake fluid leaks and brake pad wear. If necessary, refill the reservoir with brake fluid to the MAX line after repair or replaceme ...
Lexus RX (RX 350L, RX450h) 2016-2023 Repair Manual > Automatic Transaxle System: Pressure Control Solenoid "D" Actuator Stuck Off (P27137F)
DESCRIPTION Based on signals from the accelerator position sensor and transmission revolution sensors (NT, NC3 and NC), the ECM controls the shift solenoid valve SLT using a predetermined current. As a result, the line pressure is adjusted to a pressure that is appropriate for the throttle angle and ...