INSTALLATION
PROCEDURE
1. INSTALL SPARK PLUG
HINT:
Perform "Inspection After Repair" after replacing a spark plug.
Click here
(a) Install the 6 spark plugs to the cylinder head sub-assembly and cylinder head LH.
Torque:
18 N·m {184 kgf·cm, 13 ft·lbf}
NOTICE:
If a spark plug has been struck or dropped, replace it.
HINT:
Install the same parts to their original positions.
2. INSTALL IGNITION COIL ASSEMBLY
HINT:
Perform "Inspection After Repair" after replacing an ignition coil assembly.
Click here
(a) Install the 6 ignition coil assemblies to the cylinder head cover sub-assembly and cylinder head cover sub-assembly LH with the 6 bolts.
Torque:
10 N·m {102 kgf·cm, 7 ft·lbf}
NOTICE:
If an ignition coil assembly has been struck or dropped, replace it.
HINT:
Install the same parts to their original positions.
(b) Connect the 6 ignition coil assembly connectors.
3. INSTALL INTAKE AIR SURGE TANK ASSEMBLY
Click here
4. PERFORM INITIALIZATION
(a) Perform "Inspection After Repair" after replacing an ignition coil assembly and spark plug.
Click here
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Condenser: Reassembly
REASSEMBLY PROCEDURE 1. INSTALL COOLER DRYER (a) Using pliers, install a new cooler dryer to the modulator. *a Modulator (b) Sufficiently apply compressor oil to 3 O-rings and the fitting surfaces of a new cap. Compressor Oil: ND-OIL 12 or equivalent NOTICE: Keep the O ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Noise Filter (w/o Rear No. 2 Seat): On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT RADIO SETTING CONDENSER (a) With the radio setting condenser installed, check that there is no looseness or other abnormalities. (b) Measure the resistance of the radio setting condenser according to the value(s) in the table below. Standard Resistance: ...