INSTALLATION
PROCEDURE
1. INSTALL V-RIBBED BELT
| (a) Install the V-ribbed belt. NOTICE:
|
|
(b) Turn the V-ribbed belt tensioner assembly counterclockwise and remove the 5 mm hexagon wrench.
| (c) After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Confirm that the V-ribbed belt has not slipped out of the grooves on the bottom of the pulley by hand. |
|
2. INSTALL FRONT FENDER APRON SEAL RH
Click here
3. INSTALL FRONT WHEEL RH
Click here
Removal
EngineLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Can Communication System: Check Bus 5 Line for Short to +B
DESCRIPTION There may be a short circuit between one of the CAN bus lines and +B when no resistance exists between terminal 15 (CA5H) of the network gateway ECU and terminal 16 (BAT) of the DLC3, or terminal 16 (CA5L) of the network gateway ECU and terminal 16 (BAT) of the DLC3. Symptom Trouble ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Vehicle Stability Control System: Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. HINT: Using the Techstream to read the Data List allows the values or states of ...