General Maintenance
GENERAL MAINTENANCE
PROCEDURE
1. INSPECT BRAKE LINE PIPES AND HOSES
HINT:
Work in a well-lighted area. Turn the front wheels fully to the right or left before beginning the inspection.
(a) Using a mirror, check the entire circumference and length of the brake lines and hoses for:
(b) Check all the clamps for tightness and check the connections for leakage.
(c) Check that the hoses and lines are not near sharp edges, moving parts or the exhaust system.
(d) Check that the lines are installed properly and pass through the center of the grommets.
2. INSPECT BRAKE PEDAL
(a) Check the brake pedal.
Click here
3. INSPECT PARKING BRAKE
(a) Check the parking brake.
4. INSPECT FRONT BRAKE
(a) Check the front brake pads and discs.
Click here
5. INSPECT REAR BRAKE
(a) Check the rear brake pads and discs.
Click here
6. INSPECT OR CHANGE BRAKE FLUID
(a) Inspect or change the brake fluid.
Click here
Fluid:
SAE J1703 or FMVSS No. 116 DOT 3
Body
ChassisLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Fog Light Assembly: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fog light assembly removal/installation are shown below. Necessary Procedure After Parts Removed/Install ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Blind Spot Monitor System: Parts Location
PARTS LOCATION ILLUSTRATION *A w/o Rear No.2 Seat - - *1 OUTER REAR VIEW MIRROR ASSEMBLY LH *2 OUTER REAR VIEW MIRROR ASSEMBLY RH *3 OUTER MIRROR CONTROL ECU ASSEMBLY LH *4 OUTER MIRROR CONTROL ECU ASSEMBLY RH *5 BRAKE ACTUATOR ASSEMBLY - SKID CONTROL ECU *6 E ...