INSTALLATION
CAUTION / NOTICE / HINT
PROCEDURE
1. INSTALL FORWARD RECOGNITION CAMERA
NOTICE:
Forward recognition hood removal: Click here
Forward recognition hood installation: Click here
(a) When using a new forward recognition camera (w/ Protective Film):
| (1) Remove the protective film. NOTICE: Do not touch the camera lens after removing the protective film. |
|
(b) Engage the 4 guides as shown in the illustration.
NOTICE:
Do not touch the camera lens.
| Install in this Direction |
(c) Connect the connector to install the forward recognition camera.
2. INSTALL FORWARD RECOGNITION LATCH
NOTICE:
Before installing the forward recognition latch, be sure to check that the forward recognition camera is securely installed.
(a) Engage the 4 guides and 2 claws as shown in the illustration to install the forward recognition latch.
| Install in this Direction |
3. INSTALL NO. 1 FORWARD RECOGNITION COVER
(a) Engage the 2 clips and 2 guides as shown in the illustration to install the No. 1 forward recognition cover.
| Install in this Direction |
4. INSTALL NO. 2 FORWARD RECOGNITION COVER
(a) Engage the 2 guides and 2 claws as indicated by the arrows, in the order shown in the illustration to install the No. 2 forward recognition cover.
| Install in this Direction (1) |
| Install in this Direction (2) |
5. ADJUST FORWARD RECOGNITION CAMERA
(a) If the forward recognition camera has been replaced with a new one or the windshield glass has been removed and installed, it is necessary to perform Forward Recognition Camera Learning.
HINT:
Forward Recognition Camera Learning can be performed by using either One Time Recognition or Sequential Recognition.
One Time Recognition: Click here
Sequential Recognition: Click here
Removal
Before Starting AdjustmentLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Automatic Transaxle System: System Voltage Circuit Short to Ground or Open (P056014)
DESCRIPTION The battery supplies electricity to the ECM even when the engine switch is off. This power allows the ECM to store data such as DTC history and freeze frame data. If the battery voltage falls below a minimum level, the stored ECM data will be cleared and the ECM will determine that there ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Hood: Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE HOOD TO RADIATOR SUPPORT SEAL (a) Using a clip remover, disengage the 10 hood to radiator support seal clips to remove the hood to radiator support seal. (b) Remove the 10 hood to radiator support seal clips from the hood to radiator support seal. 2. RE ...