UTILITY
NOTICE:
HINT:
Forward recognition camera adjustment can be performed by using either One Time Recognition or Sequential Recognition.
One Time Recognition: Click here
Sequential Recognition: Click here
Recognition Camera/Target Position Memory
HINT:
Recognition Camera/Target Position Memory is used to enter required information into the forward recognition camera.
(a) Perform Recognition Camera/Target Position Memory according to the display on the Techstream.
Chassis > Front Recognition Camera > Utility| Tester Display |
|---|
| Recognition Camera/Target Position Memory |
HINT:
For forward recognition camera adjustment procedures.
Forward recognition camera adjustment can be performed by using either One Time Recognition or Sequential Recognition.
One Time Recognition: Click here
Sequential Recognition: Click here
HINT:
Recognition Camera Axis Adjust is used to calibrate the internal data of the forward recognition camera to enhance its recognition accuracy.
Recognition Camera Axis Adjust
(a) Perform Recognition Camera Axis Adjust according to the display on the Techstream.
Chassis > Front Recognition Camera > Utility| Tester Display |
|---|
| Recognition Camera Axis Adjust |
HINT:
For forward recognition camera adjustment procedures.
Forward recognition camera adjustment can be performed by using either One Time Recognition or Sequential Recognition.
One Time Recognition: Click here
Sequential Recognition: Click here
PCS Image Information Clear
HINT:
PCS Image Information Clear is used to clear the PCS Image Information data.
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / front recognition camera / Utility / PCS Image Information Clear.
(e) Perform PCS Image Information Clear according to the display on the Techstream.
Chassis > Front Recognition Camera > Utility| Tester Display |
|---|
| PCS Image Information Clear |
PCS Image Record Setting
HINT:
PCS Image Record Setting is used to activate/deactivate the PCS image recording function.
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / front recognition camera / Utility / PCS Image Record Setting.
(e) Perform PCS Image Record Setting according to the display on the Techstream.
Chassis > Front Recognition Camera > Utility| Tester Display |
|---|
| PCS Image Record Setting |
How To Proceed With Troubleshooting
Problem Symptoms TableLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Steering Pad Switch: Installation
INSTALLATION PROCEDURE 1. INSTALL STEERING PAD SWITCH ASSEMBLY (a) Engage the 2 claws and 2 pins to install the steering pad switch assembly. (b) Install the 2 screws. Torque: 2.4 N·m {24 kgf·cm, 21 in·lbf} (c) Connect the steering pad switch connector to the spiral cable with sensor sub-assembl ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Power Outlet Socket (w/o Rear No. 2 Seat): Components
COMPONENTS ILLUSTRATION *A except TMMC Made *B for TMMC Made *1 DECK BOARD ASSEMBLY *2 DECK SIDE TRIM BOX RH *3 FRONT DECK FLOOR BOX *4 REAR DECK FLOOR BOX *5 REAR FLOOR FINISH PLATE *6 REAR NO. 3 FLOOR BOARD *7 REAR NO. 4 FLOOR BOARD *8 TONNEAU COVE ...