UTILITY
NOTICE:
Click here
Front Beam Axis Adjustment
HINT:
Front Beam Axis Adjustment is used to calibrate the beam axis of millimeter wave radar sensor assembly.
(a) Perform Front Beam Axis Adjustment according to the display on the Techstream.
Body Electrical > Front Radar Sensor > Utility Tester Display |
---|
Front Beam Axis Adjustment |
Front Beam Axis Misalignment Reading
HINT:
Front Beam Axis Misalignment Reading is used to check the amount of misalignment of the millimeter wave radar sensor assembly.
(a) Perform Front Beam Axis Misalignment Reading according to the display on the Techstream.
Body Electrical > Front Radar Sensor > Utility Tester Display |
---|
Front Beam Axis Misalignment Reading |
Front Radar Acceleration Sensor Calibration
HINT:
Front Radar Acceleration Sensor Calibration is used to perform calibration of the acceleration sensor in the millimeter wave radar sensor assembly.
(a) Perform Front Radar Acceleration Sensor Calibration according to the display on the Techstream.
Body Electrical > Front Radar Sensor > Utility Tester Display |
---|
Front Radar Acceleration Sensor Calibration |
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Headup Display System: Lost Communication with EMV (B1321)
DESCRIPTION After the headup display (meter mirror sub-assembly) has started, the headup display (meter mirror sub-assembly) attempts to detect the radio receiver assembly by performing communication via local bus. This DTC is stored when the radio receiver assembly has been detected but communicati ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Charging System: Charging Failure
PROCEDURE 1. CHECK GENERATOR PULLEY WITH CLUTCH (ON-VEHICLE INSPECTION) (a) Start the engine and visually check that the generator rotor assembly (fan) in the generator assembly is operating. OK: The generator rotor assembly (fan) is operating. NG REPLACE GENERATOR PULLEY WITH CLUTC ...