FREEZE FRAME DATA
DESCRIPTION
(a) Whenever a road sign assist system DTC is stored, the forward recognition camera stores the current vehicle state (ECU and sensor information) as Freeze Frame Data.
CHECK FREEZE FRAME DATA
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Road Sign Assist / Trouble Codes.
Body Electrical > Road Sign Assist > Trouble Codes(e) According to the Techstream display, select a DTC that stored freeze frame data.
(f) Read the freeze frame data recorded when the DTC was stored.
Body Electrical > Road Sign Assist Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
---|---|---|---|---|
Total Distance Traveled | - | - | - | Cannot be used |
Total Distance Traveled - Unit | - | - | - | Cannot be used |
Traffic Sign Estimated Speed Unit | - | - | - | Cannot be used |
Traffic Sign Estimated Traffic Division | - | - | - | Cannot be used |
RSA Navigation Fusion Control | RSA navigation fusion control setting | OFF or ON | OFF: RSA navigation fusion control off ON: RSA navigation fusion control on | - |
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Hood Lock Control Cable Assembly: Installation
INSTALLATION PROCEDURE 1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY (a) Tie the string that was passed through the grommet to the end of the hood lock control cable assembly. HINT:
When changing the hood lock control cable assembly from type A to type B, the hood lock control lever sub-assembly mu ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Rear Seat Inner Belt Assembly(for Rh Side): Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear seat inner belt assembly removal/installation are shown below. Necessary Procedure After Parts Remo ...