DATA LIST / ACTIVE TEST
DATA LIST
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Road Sign Assist / Data List.
(e) Read the Data List according to the display on the Techstream.
Body Electrical > Road Sign Assist > Data List| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Total Distance Traveled | - | - | - | Cannot be used |
| Total Distance Traveled - Unit | - | - | - | Cannot be used |
| Traffic Sign Estimated Speed Unit | - | - | - | Cannot be used |
| Traffic Sign Estimated Traffic Division | - | - | - | Cannot be used |
| RSA Navigation Fusion Control | RSA navigation fusion control setting | OFF or ON | OFF: RSA navigation fusion control off ON: RSA navigation fusion control on | - |
Fail-safe Chart
Diagnostic Trouble Code ChartLexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Automatic Transaxle System: Input/Turbine Speed Sensor "A" Circuit Short to Battery (P071512,P071514,P071531)
DESCRIPTION The transmission revolution sensor (NT) detects the input shaft rotation speed and sends it to the ECM. Based on the transmission revolution sensor (NT) signal and the transmission revolution sensor (NC3 and NC) signals, the ECM controls engine torque and shift timing. Based on the input ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Rear Air Conditioning Unit: Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE REAR BLOWER MOTOR WITH FAN SUB-ASSEMBLY (a) Remove the 3 screws and rear blower motor with fan sub-assembly. 2. REMOVE BLOWER MOTOR CONTROL (a) Remove the 2 screws and blower motor control. 3. REMOVE REAR NO. 2 COOLING UNIT DAMPER SERVO S ...