DESCRIPTION
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| B1003 | ECU Malfunction | The network gateway ECU detects an internal malfunction. | Network gateway ECU | - |
PROCEDURE
| 1. | RECONFIRM DTC OUTPUT |
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Central Gateway / Trouble Codes.
Body Electrical > Central Gateway > Trouble Codes| Result | Proceed to |
|---|---|
| DTC B1003 is not output from the network gateway ECU (Techstream display: Central Gateway) | A |
| DTC B1003 is output from the network gateway ECU (Techstream display: Central Gateway) | B |
| A | | USE SIMULATION METHOD TO CHECK |
| B | | REPLACE NETWORK GATEWAY ECU |
Diagnostic Trouble Code Chart
Lost Communication with "Door Control Module B" (U0200)Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Automatic Transaxle System: Transmission Fluid Temperature Sensor "A" Circuit Short to Battery or Open (P071015)
DESCRIPTION The ATF temperature sensor converts the automatic transaxle fluid (ATF) temperature into a resistance value for use by the ECM. The ECM applies voltage to the temperature sensor through terminal THO1 of the ECM. The sensor resistance changes with the ATF temperature. As the temperature r ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Navigation System: Data Signal Circuit between Radio Receiver and Stereo Jack Adapter
DESCRIPTION The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the radio receiver assembly via this circuit. WIRING DIAGRAM PROCEDURE 1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) (a) ...