CAUTION / NOTICE / HINT
HINT:
PROCEDURE
| 1. | VEHICLE BROUGHT TO WORKSHOP |
|
| 2. | INSPECT BATTERY VOLTAGE |
(a) Turn the engine switch off.
(b) Measure the voltage of the battery.
Standard Voltage:
11 to 14 V
HINT:
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
|
| 3. | CHECK DTC AND FREEZE FRAME DATA* |
HINT:
Refer to DTC Check / Clear.
Click here
|
| 4. | PROBLEM SYMPTOM CONFIRMATION |
| Result | Proceed to |
|---|---|
| Symptom does not occur. | A |
| Symptom occurs. | B |
| B | | GO TO STEP 6 |
|
| 5. | SYMPTOM SIMULATION |
|
| 6. | CHECK CAN COMMUNICATION SYSTEM* |
(a) Check for DTCs.
Click here
| Result | Proceed to |
|---|---|
| CAN communication system DTCs are not output. | A |
| CAN communication system DTCs are output. | B |
HINT:
| B | | PROCEED TO CAN COMMUNICATION SYSTEM |
|
| 7. | CHECK FOR DTC* |
(a) Check for DTCs.
Click here
HINT:
Refer to Diagnostic Trouble Code Chart when any DTCs are output.
Click here
| Result | Proceed to |
|---|---|
| DTCs are not output. | A |
| DTCs are output. | B |
| B | | GO TO STEP 10 |
|
| 8. | PROBLEM SYMPTOMS TABLE |
(a) Refer to Problem Symptoms Table.
Click here
| Result | Proceed to |
|---|---|
| Fault is not listed in Problem Symptoms Table. | A |
| Fault is listed in Problem Symptoms Table. | B |
| B | | GO TO STEP 10 |
|
| 9. | OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a) Refer to Terminals of ECU.
Click here
(b) Refer to Data List / Active Test.
Click here
|
| 10. | REPAIR OR REPLACE |
|
| 11. | CONFIRMATION TEST |
| NEXT | | END |
Freeze Frame Data
On-vehicle InspectionLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Steering Lock System: Diagnosis System
DIAGNOSIS SYSTEM DESCRIPTION (a) The steering lock ECU (steering lock actuator or upper bracket assembly) stores DTCs when a malfunction occurs in the system. These DTCs can be confirmed by using the Techstream. NOTICE:
When using the Techstream with the engine switch off to confirm DTCs or Data ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Panoramic View Monitor System: Camera Position Adjustment Incomplete (C1697)
DESCRIPTION This DTC is stored when the parking assist ECU judges that the camera initial setting has not been memorized (camera view adjustment is incomplete). DTC No. Detection Item DTC Detection Condition Trouble Area C1697 Camera Position Adjustment Incomplete Camera initial set ...