REMOVAL
PROCEDURE
1. REMOVE INSTRUMENT PANEL GARNISH LH
Click here
2. REMOVE FRONT DOOR SCUFF PLATE LH
w/ Rear No. 2 Seat: Click here
w/o Rear No. 2 Seat: Click here
3. REMOVE COWL SIDE TRIM BOARD LH
Click here
4. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
5. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Click here
6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
Click here
7. REMOVE STEERING HEATER SWITCH (INTEGRATION CONTROL AND PANEL ASSEMBLY)
| (a) Disengage the 4 claws to remove the steering heater switch (integration control and panel assembly). |
|
InstallationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Sfi System: Intake Air Temperature Sensor 1 Bank 1 Circuit Short to Battery or Open (P011015)
DESCRIPTION Refer to DTC P011011. Click here HINT: When DTC P011015 is stored, the ECM enters fail-safe mode. During fail-safe mode, the intake air temperature is estimated to be 20°C (68°F) by the ECM. Fail-safe mode continues until a pass condition is detected, and the engine switch is then tu ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Audio And Visual System (for 12.3 Inch Display): Speed Signal Malfunction (B15C2)
DESCRIPTION The navigation ECU receives a vehicle speed signal from the combination meter assembly and information from the navigation antenna, and then adjusts the vehicle position. The navigation ECU stores this DTC when the difference between the speed information that the navigation antenna asse ...