SYSTEM DESCRIPTION
UNLOCK OPERATION CONDITIONS FOR STEERING LOCK
(a) When the following condition is met, the unlock operation is performed.
HINT:
When the engine switch is turned on (ACC) or on (IG) and the key and certification ECU (smart key ECU assembly) are verified, the steering is unlocked.
(b) When any of the following conditions are met, key verification is performed.
HINT:
LOCK OPERATION CONDITIONS FOR STEERING LOCK
(a) When all of the following conditions are met and the certification ECU (smart key ECU assembly) has been verified, the lock operation is performed.
HINT:
*: This is the lock/unlock operation with the mechanical key.
WARNING FUNCTION
(a) A check smart access system message is displayed on the multi-information display in the combination meter assembly when one of the following occurs: 1) A vehicle speed signal malfunction is detected, 2) a malfunction that interferes with steering lock ECU (steering lock actuator or upper bracket assembly) operation is detected.
If a malfunction occurs which results in the message being displayed, the engine cannot be started once it is turned off.
HINT:
DTCs are stored in all cases listed above.
STEERING LOCK ECU (STEERING LOCK ACTUATOR OR UPPER BRACKET ASSEMBLY) DESCRIPTION
(a) The steering lock ECU and steering lock motor are built into the steering lock actuator or upper bracket assembly of the steering column assembly.
(b) The steering lock ECU (steering lock actuator or upper bracket assembly) is not connected to the CAN communication system. However, the steering lock ECU (steering lock actuator or upper bracket assembly) is connected to the certification ECU (smart key ECU assembly) via LIN communication and communicates with other components via CAN communication through the certification ECU (smart key ECU assembly).
Steering Lock does not Lock
System DiagramLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Cylinder Block: Reassembly
REASSEMBLY PROCEDURE 1. INSTALL NO. 1 OIL NOZZLE SUB-ASSEMBLY (a) Using a 5 mm hexagon socket wrench, install the 3 No. 1 oil nozzle sub-assemblies to the cylinder block sub-assembly with the 3 bolts. Torque: 9.0 N·m {92 kgf·cm, 80 in·lbf} 2. INSTALL PISTON HINT: Perform this proc ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear No. 1 Seat Inner Belt Assembly(for 60/40 Split Seat Type Rh Side): Components
COMPONENTS ILLUSTRATION *1 NO. 1 RECLINING ADJUSTER RELEASE HANDLE RH *2 REAR NO. 1 SEAT RECLINING ADJUSTER INSIDE COVER *3 REAR SEAT 3 POINT TYPE BELT ASSEMBLY RH *4 REAR SEAT COVER CAP RH *5 REAR SEAT LOCK CONTROL LEVER SUB-ASSEMBLY RH *6 SEPARATE TYPE REAR SEAT CUSHI ...