INSPECTION
PROCEDURE
1. INSPECT HAZARD WARNING SWITCH (RADIO RECEIVER ASSEMBLY)
(a) Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected (Hazard Warning Signal Switch (Radio Receiver Assembly)) | - | - |
Standard Resistance:
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B-10 (HAZ) - A-1 (GND1) | Hazard warning signal switch off | 10 MΩ or higher |
| Hazard warning signal switch on | Below 125 Ω |
If the result is not as specified, replace the hazard warning signal switch (radio receiver assembly).
(b) Hazard warning signal switch indicator inspection
| *a | Component without harness connected (Hazard Warning Signal Switch (Radio Receiver Assembly)) | - | - |
(1) Apply battery voltage to the hazard warning signal switch (radio receiver assembly) and check that the hazard warning signal switch indicator illuminates.
OK:
| Condition | Specified Condition |
|---|---|
| Battery positive (+) → B-11 (LJB) Battery negative (-) → A-1 (GND1) | Illuminates |
If the result is not as specified, replace the hazard warning signal switch (radio receiver assembly).
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Automatic Transaxle System: Internal Control Module EEPROM Data Memory Failure (P062F44)
DESCRIPTION The ECM monitors its internal operation and will store this DTC when it detects an internal malfunction. DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P062F44 Internal Control Module EEPROM Data Memory Failure ECM internal malfunction ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Wiper Switch: On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY (a) Check the front washer operation. (1) Connect a voltmeter positive (+) lead to terminal J31-5 (WR) and a negative (-) lead to terminal J33-7 (WF). *a Component with harness connected (Windshield Wiper S ...