TERMINALS OF ECU
CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY
| *A | w/o Seat Heater System | *B | w/ Seat Heater System |
(a) Disconnect the J43 air conditioning amplifier assembly connector.
(b) Measure the voltage and resistance according to the value(s) in the table below.
HINT:
Measure the values on the wire harness side with the connector disconnected.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| J43-2 (IG+) - J43-4 (GND) | GR - W-B | Power source (IG) | Engine switch on (IG) | 11 to 14 V |
| J43-2 (IG+) - J43-4 (GND) | GR - W-B | Power source (IG) | Engine switch off | Below 1 V |
| J43-1 (B) - J43-4 (GND) | R - W-B | Battery power supply | Always | 11 to 14 V |
| J43-4 (GND) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
(c) Reconnect the J43 air conditioning amplifier assembly connector.
(d) Measure the voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| J43-17 (FDEF) - J43-4 (GND) | W - W-B | Wiper Deicer signal | Engine switch on (IG), Front wiper deicer switch off | 11 to 14 V |
| J43-17 (FDEF) - J43-4 (GND) | W - W-B | Wiper Deicer signal | Engine switch on (IG), Front wiper deicer switch on | Below 2.2 V |
Problem Symptoms Table
Data List / Active TestLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Audio And Visual System (for 8 Inch Display): Sound Signal Circuit between Radio Receiver and Stereo Component Amplifier
DESCRIPTION The radio receiver assembly sends a sound signal to the stereo component amplifier assembly via this circuit. The sound signal that has been sent is amplified by the stereo component amplifier assembly, and then is sent to the speakers. If there is an open or short in the circuit, sound ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Pre-collision System Warning Buzzer: Inspection
INSPECTION PROCEDURE 1. INSPECT SKID CONTROL BUZZER ASSEMBLY (a) Make sure that there is no looseness in the locking part and connecting part of the connector. (b) Disconnect the skid control buzzer assembly connector. (c) Check the connector and terminals for deformation and corrosio ...