REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front lumbar power seat switch removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
|
*: When performing learning using the Techstream.
Click here | |||
| Disconnect cable from negative battery terminal | Memorize steering angle neutral point | Lane Control System | |
| Pre-collision System | |||
| Intelligent Clearance Sonar System* | |||
| Parking Assist Monitor System | | ||
| Panoramic View Monitor System | | ||
| Lighting System (w/ Automatic Headlight Beam Level Control System) | | ||
| Initialize back door lock | Power Door Lock Control System | | |
| Reset back door close position | Power Back Door System (w/ Outside Door Control Switch) | | |
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
HINT:
PROCEDURE
1. REMOVE FRONT SEAT ASSEMBLY
Click here
2. DISCONNECT FRONT SEATBACK BOARD SUB-ASSEMBLY
Click here
3. REMOVE FRONT SEAT CUSHION SHIELD (for Standard Seat Type)
Click here
4. REMOVE INNER NO. 1 FRONT SEAT CUSHION SHIELD (for Sports Seat Type)
Click here
5. REMOVE FRONT SEAT CUSHION SHIELD (for Sports Seat Type)
Click here
6. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB (w/ Seat Position Memory System)
Click here
7. REMOVE RECLINING POWER SEAT SWITCH KNOB (w/ Seat Position Memory System)
Click here
8. REMOVE POSITION CONTROL ECU AND SWITCH ASSEMBLY LH (w/ Seat Position Memory System)
Click here
9. REMOVE FRONT LUMBAR POWER SEAT SWITCH
| (a) Disengage the 4 claws to remove the front lumbar power seat switch from the front seat cushion shield. |
|
Components
InspectionLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Panoramic Moon Roof System: Diagnosis System
DIAGNOSIS SYSTEM DESCRIPTION (a) Panoramic moon roof system data and Diagnostic Trouble Codes (DTCs) can be read through the vehicle Data Link Connector 3 (DLC3). When the system seems to be malfunctioning, use the Techstream to check for malfunctions and perform repairs. CHECK DLC3 (a) Check the DL ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Intelligent Clearance Sonar System: ENG / EHV Device (C1A40)
DESCRIPTION When an EFI system malfunction signal sent by the ECM is detected by the clearance warning ECU assembly, DTC C1A40 is stored. DTC No. Detection Item DTC Detection Condition Trouble Area C1A40 ENG / EHV Device When the engine switch is on (IG), an EFI system malfunction s ...