PROBLEM SYMPTOMS TABLE
HINT:
| Symptom | Suspected Area | Link |
|---|---|---|
| No functions operate. | Operation check | |
| Initialization | | |
| Proceed to "Power Source Circuit" | | |
| Fold seat control ECU | | |
| Fold/Return functions do not operate using a rear power seat switch. | Operation check | |
| Proceed to "Park/Neutral Position Switch Circuit" | | |
| Proceed to "Rear Power Seat Switch Circuit" | | |
| Proceed to "Rear Door Courtesy Switch Circuit" | | |
| Proceed to "Folding Motor Circuit" | | |
| Fold/Return functions do not operate using the fold seat switch assembly. | Operation check | |
| Proceed to "Park/Neutral Position Switch Circuit" | | |
| Proceed to "Fold Seat Switch Circuit" | | |
| Proceed to "Back Door Courtesy Switch Circuit" | | |
| Proceed to "Folding Motor Circuit" | | |
| Reclining function does not operate. | Operation check | |
| Proceed to "Fold Seat Switch Circuit" | | |
| Proceed to "Reclining Motor Circuit" | | |
| Fold seat control ECU | | |
| Buzzer sounds continuously while engine switch is on (IG) and functions do not operate. | Operation check | |
| Initialization | | |
| Proceed to "Power Source Circuit" | | |
| Fold seat control ECU | | |
| Seatback only operates partway. | Operation check | |
| Initialization | | |
| Proceed to "Reclining Motor Circuit" | | |
| Proceed to "Folding Motor Circuit" | |
Initialization
Park / Neutral Position Switch CircuitLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Front Seat Assembly: Reassembly
REASSEMBLY CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL SEAT ADJUSTER COVER CAP (a) Install the 2 seat adj ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Mirror Control System (w/ Memory): Terminals Of Ecu
TERMINALS OF ECU CHECK OUTER MIRROR CONTROL ECU ASSEMBLY (DRIVER DOOR) (a) Disconnect the N4 outer mirror control ECU assembly (driver door) connector. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the values on the wire harness side with the con ...