ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
CAUTION:
Be sure to correctly follow the removal and installation procedures for the rear No. 1 seat outer belt assembly.
PROCEDURE
1. INSPECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY (for Vehicle not Involved in Collision)
(a) Visually check for defects with the rear No. 1 seat outer belt assembly installed to the vehicle.
(1) The defects to be checked are as follows:
OK:
No defects are found.
HINT:
If any defects are found, replace the rear No. 1 seat outer belt assembly with a new one.
2. INSPECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY (for Vehicle Involved in Collision)
(a) Visually check for defects with the rear No. 1 seat outer belt assembly removed from the vehicle.
(1) The defects to be checked are as follows:
OK:
No defects are found.
HINT:
If any defects are found, replace the rear No. 1 seat outer belt assembly with a new one.
Components
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Generator (for 150 A Type): Installation
INSTALLATION PROCEDURE 1. INSTALL GENERATOR ASSEMBLY (a) Install the wire harness clamp bracket with the bolt. Torque: 8.4 N·m {86 kgf·cm, 74 in·lbf} (b) Type A: (1) Install the generator assembly with the 2 bolts. Torque: 43 N·m {438 kgf·cm, 32 ft·lbf} (2) Temporarily install the generator ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Meter / Gauge System: Entire Combination Meter does not Operate
DESCRIPTION This circuit is the power source circuit for the combination meter assembly. This circuit provides two types of power sources; one is a constant power source, and the other is an IG power source. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE:
When replacing the combination meter asse ...