REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during quarter side speaker assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced|   Replaced Part or Performed Procedure  |    Necessary Procedure  |    Effect/Inoperative Function when Necessary Procedure not Performed  |    Link  |  
|---|---|---|---|
|   Disconnect cable from negative battery terminal  |    Memorize steering angle neutral point  |    Lane Control System  |       |  
|   Pre-collision System  |  |||
|   Intelligent Clearance Sonar System*1  |  |||
|   Parking Assist Monitor System  |       |  ||
|   Panoramic View Monitor System  |       |  ||
|   Lighting System (w/ Automatic Headlight Beam Level Control System)  |       |  ||
|   Initialize back door lock  |    Power Door Lock Control System  |       |  |
|   Reset back door close position  |    Power Back Door System (w/ Outside Door Control Switch)  |       |  
*1: When performing learning using the Techstream.
Click here 
 
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click here 
 
 HINT:
PROCEDURE
1. REMOVE TONNEAU COVER ASSEMBLY
Click here 
 
2. REMOVE DECK BOARD ASSEMBLY
Click here 
 
3. REMOVE REAR NO. 3 FLOOR BOARD
Click here 
 
4. REMOVE REAR DECK FLOOR BOX
Click here 
 
5. REMOVE REAR NO. 4 FLOOR BOARD
Click here 
 
6. REMOVE FRONT DECK FLOOR BOX (for LH Side)
Click here 
 
7. REMOVE DECK SIDE TRIM BOX RH
Click here 
 
8. REMOVE REAR FLOOR FINISH PLATE
Click here 
 
9. REMOVE REAR DOOR SCUFF PLATE LH
Click here 
 
10. REMOVE REAR SEAT ASSEMBLY LH (for LH Side)
Click here 
 
11. REMOVE REAR SEAT ASSEMBLY RH (for RH Side)
Click here 
 
12. REMOVE UPPER QUARTER TRIM PAD LH
Click here 
 
13. REMOVE REAR SEAT SIDE GARNISH LH
Click here 
 
14. REMOVE REAR FLOOR FINISH SIDE PLATE LH
Click here 
 
15. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (for LH Side)
Click here 
 
16. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (for RH Side)
Click here 
 
17. REMOVE ROPE HOOK ASSEMBLY
Click here 
 
18. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (for LH Side)
Click here 
 
19. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (for RH Side)
Click here 
 
20. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side)
Click here 
 
21. REMOVE RECLINING REMOTE CONTROL BEZEL RH (for RH Side)
w/o Rear Power Seat System:
Click here 
 
22. REMOVE FOLD SEAT SWITCH ASSEMBLY (for RH Side)
w/ Rear Power Seat System:
Click here 
 
23. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side)
Click here 
 
24. REMOVE ROOF SIDE INNER GARNISH ASSEMBLY LH
Click here 
 
25. REMOVE QUARTER SIDE SPEAKER ASSEMBLY
NOTICE:
Do not touch the speaker cone.
|   (a) Disconnect the connector.  |   
  |  
(b) Remove the bolt.
(c) Disengage the clip and remove the quarter side speaker assembly.
Components
InspectionLexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Rear Center Seat Inner Belt Assembly(w/ Rear No. 2 Seat): Components
   COMPONENTS ILLUSTRATION     *1   CENTER SEAT HINGE COVER LH   *2   NO. 1 RECLINING ADJUSTER RELEASE HANDLE RH     *3   REAR CENTER SEAT INNER BELT ASSEMBLY   *4   REAR SEAT COVER CAP RH     *5   REAR SEAT LOCK CONTROL LEVER SUB-ASSEMBLY RH   *6   SEPARATE TYPE REAR SEAT CUSHION COVER WITH PAD        ...
   
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Steering Lock System: Open / Short in Steering Lock ECU (B2781)
   DESCRIPTION The steering lock ECU and steering lock motor are built into the steering lock actuator or upper bracket assembly. The steering lock ECU (steering lock actuator or upper bracket assembly) detects whether the steering lock is in the lock or unlock position by using the lock sensor and unl ...