DESCRIPTION
This DTC is stored when the angle of the blind spot monitor sensor LH deviates more than the allowable range from the horizontal axis.
HINT:
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AC1 | Master Module Horizontal Axis Misalignment | When the blind spot monitor sensor deviates 5 degrees or more from the horizontal axis when the system is activated | Blind spot monitor sensor LH |
CAUTION / NOTICE / HINT
NOTICE:
When checking for DTCs, make sure that the blind spot monitor system is turned on.
PROCEDURE
| 1. | CHECK VEHICLE CONDITION |
(a) Check the condition of the rear bumper around the blind spot monitor sensors.
HINT:
When mud, snow, ice, a sticker, etc. is covering the sensor or its surrounding area on the rear bumper, the blind spot monitor sensor may store this DTC by mistake.
| Result | Proceed to |
|---|---|
| A sticker, mud, snow, ice, etc. is covering the sensor or surrounding area on the rear bumper. | A |
| There are scratches or dents on the rear bumper around the sensors. | B |
| No abnormalities. |
| B | | GO TO STEP 3 |
|
| 2. | PERFORM BEAM AXIS CONFIRMATION |
(a) Clean the rear bumper.
(b) Perform Blind Spot Monitor Beam Axis Confirmation using the Techstream.
Click here
| Tester Display |
|---|
| BSM Master Beam Axis Display |
| Tester Display |
|---|
| BSM Master Beam Axis Adjustment |
| OK | | END |
| NG | | REPLACE BLIND SPOT MONITOR SENSOR LH |
| 3. | CHECK INSTALLATION CONDITION |
(a) Check the installation condition of the blind spot monitor sensor LH.
Click here
HINT:
Take the appropriate action in accordance with the result.
|
| 4. | PERFORM BEAM AXIS CONFIRMATION |
(a) Install the rear bumper.
REAR BUMPER (w/o Rear No. 2 Seat): Click here
REAR BUMPER (w/ Rear No. 2 Seat): Click here
(b) Perform Blind Spot Monitor Beam Axis Confirmation using the Techstream.
Click here
| Tester Display |
|---|
| BSM Master Beam Axis Display |
| Tester Display |
|---|
| BSM Master Beam Axis Adjustment |
| OK | | END |
| NG | | REPLACE BLIND SPOT MONITOR SENSOR LH |
Short to +B in Buzzer (C1ABD,C1ABE)
Slave Module Horizontal Axis Misalignment (C1AC2)Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Safety Connect System: Acn Call End
ACN CALL END ACN CALL END This function terminates the ACN (Automatic Collision Notification) to the telematics provider. After a collision in which the DCM receives "Collision Detection Signal", the vehicle will send the emergency call notification to the telematics provider until the emergency cal ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Front Door Speaker: Inspection
INSPECTION PROCEDURE 1. INSPECT FRONT NO. 1 SPEAKER ASSEMBLY (a) With the speaker installed, check that there is no looseness or other abnormalities. (b) Check that there is no foreign matter in the speaker, no tears on the speaker cone or other abnormalities. (c) Measure the resistance of the sp ...