Components
COMPONENTS
ILLUSTRATION
| *1 | NO. 1 CLEARANCE WARNING BUZZER | - | - |
Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during No. 1 clearance warning buzzer removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
|
*1: When performing learning using the Techstream.
Click here | |||
| Disconnect cable from negative battery terminal | Memorize steering angle neutral point | Lane Control System | |
| Pre-collision System | |||
| Intelligent Clearance Sonar System*1 | |||
| Parking Assist Monitor System | | ||
| Panoramic View Monitor System | | ||
| Lighting System (w/ Automatic Headlight Beam Level Control System) | | ||
| Initialize back door lock | Power Door Lock Control System | | |
| Reset back door close position | Power Back Door System (w/ Outside Door Control Switch) | | |
PROCEDURE
1. REMOVE RADIO RECEIVER ASSEMBLY WITH REGISTER
Click here
2. REMOVE NO. 1 CLEARANCE WARNING BUZZER
| (a) Disconnect the connector. |
|
(b) Disengage the clamp and remove the No. 1 clearance warning buzzer.
Power Source CircuitLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Electrical Key Oscillator (for Front Floor): Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY (a) Engage the clamp to install the No. 1 indoor electrical key antenna assembly as shown in the illustration. NOTICE: Be careful when installing the No. 1 indoor electrical key antenna assembly. If the No. 1 indoor elect ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Can Communication System: Check Bus 3 Line for Short to +B
DESCRIPTION There may be a short circuit between one of the CAN bus lines and +B when there is no resistance between terminal 6 (CA3H) of the network gateway ECU and terminal 16 (BAT) of the DLC3, or terminal 21 (CA3L) of the network gateway ECU and terminal 16 (BAT) of the DLC3. Symptom Troubl ...