INITIALIZATION
INITIALIZE PARKING ASSIST MONITOR SYSTEM
(a) When "!" mark is displayed on the multi-display assembly, correct the steering angle neutral point using the following method.
(1) Fully turn the steering wheel to the right and left on level ground.
NOTICE:
Memorizing the steering angle neutral point must be carried out with the engine running. Apply the parking brake, depress the brake pedal, check that the shift lever is in P, and ensure that the vehicle is not moving.
HINT:
If "!" mark is displayed on the image of the area behind the vehicle with the steering wheel fully turned to the right or left, perform "Steering Angle Setting in Calibration".
Click here
How To Proceed With Troubleshooting
CalibrationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Exterior Panels / Trim: Wheel Opening Moulding(for Rear Side)
ComponentsCOMPONENTS ILLUSTRATION *1 QUARTER OUTSIDE MOULDING SUB-ASSEMBLY - - ● Non-reusable part - - RemovalREMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE QUA ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Steering Pad Switch: Installation
INSTALLATION PROCEDURE 1. INSTALL STEERING PAD SWITCH ASSEMBLY (a) Engage the 2 claws and 2 pins to install the steering pad switch assembly. (b) Install the 2 screws. Torque: 2.4 N·m {24 kgf·cm, 21 in·lbf} (c) Connect the steering pad switch connector to the spiral cable with sensor sub-assembl ...