INSTALLATION
CAUTION / NOTICE / HINT
NOTICE:
A lock pin is installed to a new steering sensor. Do not remove the lock pin before the steering sensor is installed to the spiral cable sub-assembly.
PROCEDURE
1. INSPECT SPIRAL CABLE SUB-ASSEMBLY
Click here
2. INSTALL STEERING SENSOR
| (a) Align the 2 pins and 2 guides, and engage the 6 claws to install the steering sensor to the spiral cable sub-assembly. NOTICE:
|
|
| (b) Remove the lock pin from the steering sensor. |
|
3. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
Click here
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Audio And Visual System (for 12.3 Inch Display): MOST Communication Malfunction (B15D0)
DESCRIPTION Audio and visual system components communicate with each other via MOST communication. If a line short or short to ground occurs in a MOST communication line, communication will not be possible and the audio and visual system will not operate normally. After the engine switch is turned o ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Mirror Control System (w/o Memory): Terminals Of Ecu
TERMINALS OF ECU CHECK OUTER MIRROR CONTROL ECU ASSEMBLY (DRIVER DOOR) (a) Disconnect the N4 outer mirror control ECU assembly (driver door) connector. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the values on the wire harness side with the con ...