FAIL-SAFE CHART
FAIL-SAFE OPERATION
The brake actuator assembly turns off the solenoids and the ECM stops its VSC control according to signals from the skid control ECU. The vehicle will operate in a manner similar to a vehicle that is not equipped with ABS, TRAC, VSC and brake hold systems.
ABS control will be prohibited, but EBD control will continue to the extent that EBD control is possible. If EBD control is impossible, the brake system warning light will come on to warn the driver.
Click here
If it is impossible for control to continue, the warning light comes on to inform the driver of system control termination.
Click here
HINT:
When control is prohibited, the brake hold operated indicator light blinks, and the code for the system where the malfunction occurred during diagnostic mode is displayed by the brake hold standby indicator light.
HINT:
When control is prohibited, a message is displayed on the multi-information display in the combination meter assembly.
| Malfunction Area | Control Method |
|---|---|
| ABS system | ABS, BA, TRAC and VSC control prohibited. Brake hold control prohibited. |
| BA system | ABS, BA, TRAC and VSC control prohibited. Brake hold control prohibited. |
| EBD system | ABS, EBD, BA, TRAC and VSC control prohibited. Brake hold control prohibited. |
| Malfunction Area | Control Method |
|---|---|
| Engine control system (TRAC system) | Before control: Disables control. During control: Uses only the brakes to perform control. |
| Brake control system (VSC system) | Before control: Disables control. During control: Uses only the engine to perform control. |
| Brake control system (TRAC system) | Before control: Disables control. During control: Disables control (by gradually ending control). |
| Malfunction Area | Control Method |
|---|---|
| Airbag system (Secondary collision brake system) | Before control: Disables control. During control: Uses only the brakes to perform control. |
| Engine control system (Secondary collision brake system) | Before control: Disables control. During control: Uses only the brakes to perform control. |
Freeze Frame Data
Data List / Active TestLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Sliding Roof System: Terminals Of Ecu
TERMINALS OF ECU CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) (a) Disconnect the U2 sliding roof ECU (sliding roof drive gear sub-assembly) connector. (b) Measure the resistance and voltage according to the value(s) in the table below. HINT: Measure the values on the wire harness s ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Dynamic Torque Control Awd System: Low or High Power Supply Voltage (C1241)
DESCRIPTION If a malfunction in the power source circuit occurs, or a communication malfunction with the skid control ECU (brake actuator assembly) or speed sensor occurs, the 4WD ECU assembly prohibits operation. DTC No. Detection Item DTC Detection Condition Trouble Area C1241 Low o ...