ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. REMOVE REAR WHEEL
Click here
2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY
Click here
3. REMOVE REAR DISC
Click here
4. INSPECT REAR AXLE HUB BEARING LOOSENESS
| (a) Using a dial indicator, check for looseness near the center of the rear axle hub. Maximum Looseness: 0.05 mm (0.00196 in.) NOTICE:
HINT: If the looseness exceeds the maximum, replace the rear axle hub and bearing assembly. |
|
5. INSPECT REAR AXLE HUB RUNOUT
| (a) Using a dial indicator, check for runout on the surface of the rear axle hub outside the rear axle hub bolts. Maximum Runout: 0.08 mm (0.00314 in.) NOTICE:
HINT: If the runout exceeds the maximum, replace the rear axle hub and bearing assembly. |
|
6. INSTALL REAR DISC
Click here
7. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY
Click here
8. INSTALL REAR WHEEL
Click here
Components
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Meter / Gauge System: Lost Communication with EMV (B1321)
DESCRIPTION After the combination meter assembly has started, the combination meter assembly attempts to detect the radio receiver assembly by performing communication via local bus. This DTC is stored when the radio receiver assembly has been detected but communication between the combination meter ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Knee Airbag Assembly: Installation
INSTALLATION PROCEDURE 1. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (a) Check that the engine switch is off. (b) Check that the cable is disconnected from the negative (-) battery terminal. CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery termi ...