■ When using the Bluetooth audio system
■ When using the hands-free system
If the Bluetooth phone is too close to the system, quality of the sound may deteriorate and connection status may deteriorate.
■ Conditions under which the system will not operate
■ Bluetooth antenna The antenna is built into the display.
If the portable audio player is behind the seat or in the glove box or console box, or is touching or covered by metal objects, the connection status may deteriorate.
If the cellular phone is behind the seat or in the console box, or touching or covered by metal objects, the connection status may deteriorate.
■ Battery charge/signal status
■ When using the Bluetooth audio and hands-free system at the same time The following problems may occur.
■ About the contact in this system The following data is stored for every registered cellular phone. When another phone is connecting, you cannot read the registered data.
When removing a Bluetooth phone from the system, the above-mentioned data is also deleted.
■ About Bluetooth

WARNING
■While driving Do not operate the portable audio player, cellular phone or connect a device to the Bluetooth system.
■ Caution regarding interference with electronic devices
NOTICE
■ When leaving the vehicle Do not leave your portable audio player or cellular phone in the vehicle. The inside of the vehicle may become hot, causing damage to the portable audio player or cellular phone.
What to do if... (Troubleshooting)
Other functionLexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Wireless Door Lock Control System: Diagnosis System
DIAGNOSIS SYSTEM DESCRIPTION The main body ECU (multiplex network body ECU) stores DTCs when malfunctions occur. The diagnostic system allows for reading of the DTCs from the DLC3. Use the Techstream to check for malfunctions and perform repairs. CHECK DLC3 (a) Check the DLC3. Click here INSPECT B ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Integration Relay: Inspection
INSPECTION PROCEDURE 1. INSPECT SEMICONDUCTOR POWER INTEGRATION ECU (a) IG2 RELAY: (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition B-1 - 1F-4 Battery voltage not applied between terminals ...