INSTALLATION
PROCEDURE
1. PRECAUTION
NOTICE:
When 4WD ECU assembly is replaced with a known good one from another vehicle, it is necessary to perform calibration.
Click here
2. INSTALL 4WD ECU ASSEMBLY
| (a) Install the 4WD ECU assembly with the bolt. Torque: 8.5 N·m {87 kgf·cm, 75 in·lbf} |
|
(b) Connect the 4WD ECU assembly connector.
3. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
4. INSTALL COWL SIDE TRIM BOARD RH
Click here
5. INSTALL FRONT DOOR SCUFF PLATE RH
Click here
Click here
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
Components
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Charging System: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspect ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Dynamic Radar Cruise Control System: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE:
Before replacing the ECM, refer to Registration.
Click here
When replacing the millimeter wave radar sensor assembly, always replace it with a new one. If a millimeter wave radar sensor assembly which was installed to another vehicle is used, the information st ...