INSTALLATION
PROCEDURE
1. INSTALL AWD LOCK SWITCH (COMBINATION SWITCH ASSEMBLY)
Click here
2. INSTALL CONSOLE BOX ORNAMENT
Click here
3. INSTALL CONSOLE PANEL SUB-ASSEMBLY
Click here
4. INSTALL INSTRUMENT CLUSTER FINISH PANEL ORNAMENT
Click here
5. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
Click here
6. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
Click here
7. INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL
Click here
8. INSTALL REAR CONSOLE UPPER PANEL
Click here
InspectionLexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Sfi System: Intake Air Temperature Sensor 1 Bank 1 Circuit Short to Battery or Open (P011015)
DESCRIPTION Refer to DTC P011011. Click here HINT: When DTC P011015 is stored, the ECM enters fail-safe mode. During fail-safe mode, the intake air temperature is estimated to be 20°C (68°F) by the ECM. Fail-safe mode continues until a pass condition is detected, and the engine switch is then tu ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Air Fuel Ratio Sensor: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during air fuel ratio sensor removal/installation are shown below. Necessary Procedures After Parts Removed/Ins ...