Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT AWD LOCK SWITCH (COMBINATION SWITCH ASSEMBLY)

(a) Inspect the AWD lock switch:

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

5 (B) - 1 (GND)

AWD lock switch pushed

Below 50 Ω

AWD lock switch not pushed

10 kΩ or higher

If the result is not as specified, replace the AWD lock switch (combination switch assembly).

*a

Component without harness connected

(AWD Lock Switch (Combination Switch Assembly))

(b) Inspect the illumination:

(1) Apply battery voltage to the AWD lock switch (combination switch assembly) and check that the AWD lock switch (combination switch assembly) illuminates.

Standard:

Measurement Condition

Specified Condition

Battery positive (+) → Terminal 10 (ILL+)

Battery negative (-) → Terminal 6 (ILL-)

Illuminates

If the result is not as specified, replace the AWD lock switch (combination switch assembly).

*a

Component without harness connected

(AWD Lock Switch (Combination Switch Assembly))

    Removal
    REMOVAL PROCEDURE 1. REMOVE REAR CONSOLE UPPER PANEL Click here 2. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL Click here 3. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL Click here 4. R ...

    Installation
    INSTALLATION PROCEDURE 1. INSTALL AWD LOCK SWITCH (COMBINATION SWITCH ASSEMBLY) Click here 2. INSTALL CONSOLE BOX ORNAMENT Click here 3. INSTALL CONSOLE PANEL SUB-ASSEMBLY Click here 4. INSTALL ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Rear Seat Inner Belt Assembly(for Lh Side): Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear seat inner belt assembly removal/installation are shown below. Necessary Procedure After Parts Remo ...

    Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Airbag System: Short in D Squib (Dual Stage - 2nd Step) Circuit (B1810-B1813)
    DESCRIPTION The driver squib 2nd step circuit consists of the airbag sensor assembly, spiral cable sub-assembly and horn button assembly. The airbag sensor assembly uses this circuit to deploy the airbag when deployment conditions are met. These DTCs are stored when a malfunction is detected in the ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2025 Copyright www.lexusrx.net
    0.017