Tire inflation pressure
The recommended cold tire inflation pressure and tire size are displayed on the tire and loading information label.

Inspection and adjustment procedure

1. Remove the tire valve cap.
2. Press the tip of the tire pressure gauge onto the tire valve.
3. Read the pressure using the gauge gradations.
If the tire inflation pressure is not at the recommended level, adjust the pressure.
If you add too much air, press the center of the valve to deflate.
5. After completing the tire inflation pressure measurement and adjustment, apply soapy water to the valve and check for leakage.
6. Put the tire valve cap back on.
■ Tire inflation pressure check interval You should check tire inflation pressure every two weeks, or at least once a month.
Do not forget to check the spare.
■ Effects of incorrect tire inflation pressure Driving with incorrect tire inflation pressure may result in the following:
If a tire needs frequent inflating, have it checked by your Lexus dealer.
■ Instructions for checking tire inflation pressure When checking tire inflation pressure, observe the following:
If your vehicle has been parked for at least 3 hours or has not been driven for more than 1 mile or 1.5 km, you will get an accurate cold tire inflation pressure reading.
It is difficult to judge if a tire is properly inflated based only on its appearance.
Passengers and luggage weight should be placed so that the vehicle is balanced.
WARNING
■ Proper inflation is critical to save tire performance Keep your tires properly inflated.
If the tires are not properly inflated, the following conditions may occur which could lead to an accident resulting in death or serious injury:
NOTICE
■ When inspecting and adjusting tire inflation pressure Be sure to put the tire valve caps back on.
If a valve cap is not installed, dirt or moisture may get into the valve and cause an air leak, resulting in decreased tire inflation pressure.
Tires
WheelsLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Sfi System: Mass or Volume Air Flow Sensor "A" Signal Plausibility Failure (P010064)
DESCRIPTION Refer to DTC P010012. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P010064 Mass or Volume Air Flow Sensor "A" Signal Plausibility Failure All of the following conditions are met (2 trip detection logic):
The engine is ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Dynamic Torque Control Awd System: Calibration
CALIBRATION DESCRIPTION (a) When the 4WD ECU assembly is replaced with a known good one from another vehicle or the acceleration sensor (airbag ECU assembly*1 or yaw rate sensor assembly*2) is replaced, perform calibration. (b) Follow the chart to perform calibration. Part Replaced Necessary Op ...