REMOVAL
PROCEDURE
1. REMOVE V-BANK COVER SUB-ASSEMBLY
Click here
2. REMOVE PURGE VALVE (PURGE VSV) (for TMMC Made)
| (a) Disconnect the purge valve (purge VSV) connector. |
|
(b) Slide the clip and disconnect the fuel vapor feed hose from the purge valve (purge VSV).
(c) Disconnect the No. 1 fuel vapor feed hose from the purge valve (purge VSV).
(d) Remove the bolt and purge valve (purge VSV) from the intake air surge tank assembly.
3. REMOVE PURGE VALVE (PURGE VSV) (except TMMC Made)
| (a) Disconnect the purge valve (purge VSV) connector. |
|
(b) Slide the clip and disconnect the fuel vapor feed hose from the purge valve (purge VSV).
(c) Disconnect the No. 1 fuel vapor feed hose from the purge valve (purge VSV).
(d) Remove the bolt and purge valve (purge VSV) from the intake air surge tank assembly.
Components
InspectionLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Center Seat Outer Belt Assembly(w/o Rear No. 2 Seat): Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear center seat outer belt assembly removal/installation are shown below. Necessary Procedure After Par ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Vehicle Stability Control System: Left Front Wheel Speed Sensor Signal Stuck Low (C050023)
DESCRIPTION Refer to DTC C05001F. Click here DTC No. Detection Item DTC Detection Condition Trouble Area C050023 Left Front Wheel Speed Sensor Signal Stuck Low Any of the following is detected:
When the +BS terminal voltage is 17.4 V or less at a vehicle speed of 10 km/h (6 mph ...