Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual: Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during knock control sensor removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Battery terminal is disconnected/reconnected | Memorize steering angle neutral point | Lane Control System | |
| Pre-collision System | |||
| Intelligent Clearance Sonar System*1 | |||
| Parking Assist Monitor System | | ||
| Panoramic View Monitor System | | ||
| Lighting System (w/ Automatic Headlight Beam Level Control System) | | ||
| Initialize back door lock | Power Door Lock Control System | | |
| Reset back door close position | Power Back Door System (w/ Outside Door Control Switch) | | |
| Replacement of knock control sensor | Inspection after repair |
| |
*1: When performing learning using the Techstream.
Click here .gif)
CAUTION:
To prevent serious injury due to fuel spray from the high-pressure fuel lines, always discharge fuel system pressure before removing any fuel system components.
PROCEDURE
1. REMOVE FUEL DELIVERY PIPE
Click here
2. REMOVE KNOCK CONTROL SENSOR
| (a) Disconnect the 2 knock control sensor connectors. |
|
(b) Remove the 2 bolts and 2 knock control sensors from the cylinder block sub-assembly.
NOTICE:
If a knock control sensor has been struck or dropped, replace it.
Components
COMPONENTS ILLUSTRATION *1 KNOCK CONTROL SENSOR (for Bank 1) *2 KNOCK CONTROL SENSOR (for Bank 2) N*m (kgf*cm, ft.*lbf): Specified torque * For use with a union nut wrench ...
Inspection
INSPECTION PROCEDURE 1. INSPECT KNOCK CONTROL SENSOR (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Cond ...
Other materials:
Lexus RX (RX 350L, RX450h) 2016-2026 Owners Manual > Rear seats: Folding the third-row seat seatbacks (RX450hL)
■ Before folding the third-row seat seatbacks
1. To prevent the seat belt from
being damaged, hook it to the
seat belt hanger.
2. Lower the third-row seat head restraints to the lowest position.
■ Folding the third-row seat seatbacks
Press and hold the
side of the
switch until the se ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Power Seat Control System(for Third Row): Operation Check
OPERATION CHECK 1. CHECK FOLD FUNCTION OPERATION (a) Operating Conditions. (1) All of the following conditions are met:
Initialization (initial position memorization) has been completed.
The back door is open. (When using the No. 1 fold seat switch assembly.)
No rear No. 2 power seat fold or ...
Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual
- For your information
- Pictorial index
- For safety and security
- Instrument cluster
- Operation of each component
- Driving
- Lexus Display Audio system
- Interior features
- Maintenance and care
- When trouble arises
- Vehicle specifications
- For owners
Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual
0.0096