Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT KNOCK CONTROL SENSOR

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

1 - 2

25°C (77°F)

120 to 280 kΩ

If the result is not as specified, replace the knock control sensor.

*a

Component without harness connected

(Knock Control Sensor)

    Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during knoc ...

    Installation
    INSTALLATION PROCEDURE 1. INSTALL KNOCK CONTROL SENSOR HINT: Perform "Inspection After Repair" after replacing a knock control sensor. Click here (a) Temporarily install the 2 knock control sensors ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Airbag System: Operation Check
    OPERATION CHECK PRECAUTION FOR OPERATION CHECK CAUTION: Use the correct procedure to replace the airbag parts. CHECK SRS WARNING LIGHT (a) Primary check (1) Turn the engine switch on (IG) and check that the SRS warning light turns on. (2) Turn the engine switch off. Wait for at least 2 seconds, an ...

    Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Meter / Gauge System: Lost Communication with Clock Device (Local-CAN) (B1326)
    DESCRIPTION After the combination meter assembly has started, the combination meter assembly attempts to detect the clock assembly by performing communication via local bus. This DTC is stored when the clock assembly has been detected but communication between the combination meter assembly and cloc ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2024 Copyright www.lexusrx.net
    0.0157