ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
CAUTION:
To prevent injury due to contact with an operating V-ribbed belt or cooling fan, keep your hands and clothing away from the V-ribbed belt and cooling fans when working in the engine compartment with the engine running or the engine switch on (IG).
PROCEDURE
1. INSPECT V-RIBBED BELT
(a) Check the V-ribbed belt for wear, cracks or other signs of damage. HINT: If any of the following defects is found, replace the V-ribbed belt.
| |
(b) Check that the V-ribbed belt fits properly in the ribbed grooves. HINT: Make sure to check by hand that the V-ribbed belt has not slipped out of the grooves on the bottom of the pulley. If it has slipped out, replace the V-ribbed belt. Install a new V-ribbed belt correctly. |
|
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Steering Lock System: Terminals Of Ecu
TERMINALS OF ECU TERMINAL INSPECTION *a Component without harness connected (Steering Lock ECU (Steering Lock Actuator or Upper Bracket Assembly)) - - (a) Measure the voltage and resistance according to the value(s) in the table below. Terminal No. (Symbol) Input/Output Wiring Co ...
Lexus RX (RX 350L, RX450h) 2016-2024 Repair Manual > Blind Spot Monitor System: Blind Spot Monitor Master Module Beam Axis Inspection Incomplete (C1ABB)
DESCRIPTION This DTC is stored when a beam axis adjustment has not been performed for the blind spot monitor sensor LH. HINT: This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that a beam axis adjustment is performed. Completing the beam axis ...