REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel pressure sensor removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
|
*1: When performing learning using the Techstream.
Click here | |||
| Battery terminal is disconnected/reconnected | Memorize steering angle neutral point | Lane Control System | |
| Pre-collision system | |||
| Intelligent clearance sonar system*1 | |||
| Lighting system (w/ Automatic Headlight Beam Level Control System) | | ||
| Parking assist monitor system | | ||
| Panoramic view monitor system | | ||
| Initialize back door lock | Power door lock control system | | |
| Reset back door close position | Power Back Door System (w/ Outside Door Control Switch) | | |
| Inspection After Repair |
| |
PROCEDURE
1. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY (FUEL PRESSURE SENSOR)
Click here
NOTICE:
Components
InspectionLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Back Door Lock: Installation
INSTALLATION PROCEDURE 1. INSTALL BACK DOOR LOCK ASSEMBLY HINT: Make sure to remove the string before installing a new back door lock assembly. (a) Apply MP grease to the sliding parts of the back door lock assembly. (b) Engage the clip to temporarily install the back door lock assembly as shown in ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Seat Heater System: Lost Communication with Rear Panel LIN (B14B3)
DESCRIPTION The refreshing seat switch (for rear side)*1 or rear seat heater switch*2 communicates with the air conditioning amplifier assembly via LIN communication. If the LIN communication system is malfunctioning, the air conditioning amplifier assembly will not operate even if the refreshing se ...