On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT INTAKE AIR CONTROL VALVE (for ACIS)
(a) Remove the V-bank cover sub-assembly.
Click here
| (b) Disconnect the vacuum hose sub-assembly from the intake air control valve (for ACIS). |
|
(c) Connect a hose and vacuum pump to the intake air control valve (for ACIS).
| (d) Using the vacuum pump, apply a vacuum to the intake air control valve (for ACIS). Check that the actuator rod operates when vacuum is applied. If the actuator rod does not operate when vacuum is applied, replace the intake air surge tank assembly. |
|
(e) Using the vacuum pump, apply a vacuum to the intake air control valve (for ACIS). Check that there is no change in vacuum after 1 minute.
If the actuator rod does not operate when vacuum is applied, replace the intake air surge tank assembly.
(f) Disconnect the hose and vacuum pump from the intake air control valve (for ACIS).
(g) Connect the vacuum hose sub-assembly to the intake air control valve (for ACIS).
(h) Install the V-bank cover sub-assembly.
Click here
Removal
Intake ManifoldLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Smart Access System With Push-button Start (for Start Function): Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspect ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Seat Reclining Control Cable: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear seat reclining cable removal/installation are shown below. Necessary Procedure After Parts Removed/ ...