INSTALLATION
PROCEDURE
1. INSTALL ENGINE OIL LEVEL SENSOR
(a) Install the engine oil level sensor with the 2 bolts.
Torque:
10 N·m {102 kgf·cm, 7 ft·lbf}
(b) Install a new clip to the engine oil level sensor.
(c) Connect the engine oil level sensor connector.
2. INSTALL OIL STRAINER SUB-ASSEMBLY
Click here
3. INSTALL NO. 2 OIL PAN SUB-ASSEMBLY
Click here
4. INSTALL FRONT FRAME ASSEMBLY
Click here
5. ADD ENGINE OIL
Click here
6. CHECK ENGINE OIL LEVEL
Click here
7. INSPECT FOR OIL LEAK
Click here
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Heated Steering Wheel Controller: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the steering vibration and heater ECU removal/installation are shown below. Necessary Procedure After Part ...
Lexus RX (RX 350L, RX450h) 2016-2026 Owners Manual > Maintenance: Maintenance
requirements
To ensure safe and economical driving, day-to-day care and regular
maintenance
are essential. It is the owner's responsibility to perform regular checks.
Lexus recommends the following maintenance:
General maintenance
General maintenance should be performed on a daily basis. This can be done ...