INSPECTION
PROCEDURE
1. INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY
| (a) Disconnect the wire harness protector. |
|
(b) Disconnect the engine oil pressure switch assembly connector.
(c) Start the engine.
| (d) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the engine oil pressure switch assembly. |
|
(e) Connect the engine oil pressure switch assembly connector.
Removal
InstallationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Maintenance: Under Hood
General MaintenanceGENERAL MAINTENANCE PROCEDURE 1. GENERAL NOTES
Maintenance requirements vary depending on country.
Check the maintenance schedule in the owner's manual.
Following the maintenance schedule is mandatory.
Determine the appropriate time to service the vehicle using either mil ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Crossing Traffic Alert Buzzer (w/ Rear No. 2 Seat): Installation
INSTALLATION PROCEDURE 1. INSTALL BLIND SPOT MONITOR BUZZER (a) Connect the connector. (b) Engage the clamp to install the blind spot monitor buzzer. 2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH Click here 3. INSTALL COOLER (NO. 2 ROOM TEMP. SENSOR) THERMISTOR Click here 4. INSTALL NO. 2 AIR COND ...