REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during power outlet socket or USB charger socket removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
|
*1: When performing learning using the Techstream.
Click here | |||
| Disconnect cable from negative battery terminal | Memorize steering angle neutral point | Lane Control System | |
| Pre-collision system | |||
| Intelligent clearance sonar system*1 | |||
| Parking Assist Monitor System | | ||
| Panoramic View Monitor System | | ||
| Lighting System (w/ Automatic Headlight Beam Level Control System) | | ||
| Initialize back door lock | Power Door Lock Control System | | |
| Reset back door close position | Power Back Door System (w/ Outside Door Control Switch) | | |
PROCEDURE
1. REMOVE RADIO RECEIVER ASSEMBLY WITH REGISTER
Click here
2. REMOVE CONSOLE BOX ASSEMBLY
Click here
3. REMOVE CIGAR LIGHTER HOLE COVER
(a) Remove the cigar lighter hole cover.
4. REMOVE NO. 1 POWER OUTLET SOCKET ASSEMBLY
(a) Using a screwdriver with its tip wrapped with protective tape, disengage the claw and remove the No. 1 power outlet socket assembly as shown in the illustration.
| *a | Protective Tape |
| Remove in this Direction |
5. REMOVE POWER OUTLET SOCKET LENS
(a) Disengage the 2 claws and remove the power outlet socket lens as shown in the illustration.
| Remove in this Direction |
6. REMOVE NO. 2 USB CHARGER SOCKET
(a) Using a screwdriver with its tip wrapped with protective tape, disengage the 4 claws and remove the No. 2 USB charger socket as shown in the illustration.
| *a | Protective Tape |
| Remove in this Direction |
InstallationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Air Conditioning Filter: Installation
INSTALLATION PROCEDURE 1. INSTALL CLEAN AIR FILTER (a) Engage the 4 guides as indicated by the arrows, in the order shown in the illustration to install the clean air filter to the air filter case. Install in this Direction (1) Install in this Direction (2) NOTICE: Make sure that the ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Bumper (w/o Rear No. 2 Seat): Installation
INSTALLATION PROCEDURE 1. INSTALL REAR BUMPER ASSEMBLY (a) w/ Intuitive Parking Assist System or Kick Sensor: (1) Connect the connector. (b) Engage the 2 claws as shown in the illustration. Install in this Direction (c) Engage the 5 claws as shown in the illustration. Install in thi ...