REMOVAL
PROCEDURE
1. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
Click here
2. REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT
Click here
3. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL
Click here
4. REMOVE LOWER INSTRUMENT FINISH PANEL SUB
Click here
5. REMOVE ENGINE SWITCH
| (a) Disengage the 2 claws and remove the engine switch. |
|
Components
InspectionLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Sliding Roof Housing (for Slidng Roof): Reassembly
REASSEMBLY PROCEDURE 1. INSTALL SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY (a) Hold down the roof wind deflector panel sub-assembly. Hold Position (b) Using a screwdriver, slide the sliding roof drive cable LH as shown in the illustration to install it. *a Protective Tape Push Posi ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Steering System: Calibration
CALIBRATION TORQUE SENSOR ZERO POINT CALIBRATION (USING TECHSTREAM) NOTICE: Perform torque sensor zero point calibration if any of the following conditions occur:
The power steering ECU assembly has been replaced.
The electric power steering column sub-assembly has been replaced.
There is a d ...