INSPECTION
PROCEDURE
1. INSPECT ENGINE SWITCH
| (a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the engine switch. |
|
(b) Apply battery voltage between the terminals of the engine switch, and check the illumination condition of the engine switch indicator light.
OK:
| Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 9 (SWIL) Battery negative (-) → Terminal 6 (AGND) | Illuminates |
HINT:
If the result is not as specified, replace the engine switch.
Removal
InstallationLexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Fuel Pump (for High Pressure): On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. FUEL PUMP ASSEMBLY OPERATION (a) Check fuel pressure. (1) Connect the Techstream to the DLC3. (2) Start the engine. (3) Turn the Techstream on. (4) Enter the following menus: Powertrain / Engine / Active Test / Control the Target Fuel Pressure Offset. Powertrain &g ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Quarter Window Glass (w/ Rear No. 2 Seat): Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL QUARTER WINDOW ASSEMBLY (a) Using a brush, coat the installation surfaces on the vehicle body with primer M. NOTICE:
Do not coat ...