Components
COMPONENTS
ILLUSTRATION
| *1 | FRONT FENDER MOULDING SUB-ASSEMBLY | *2 | FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY |
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY
| (a) Engage the 5 claws and 9 clips as shown in the illustration. |
|
(b) Install the front fender moulding sub-assembly with the 4 clips.
2. CONNECT FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY
(a) Connect the front fender splash shield sub-assembly with the 2 clips.
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. DISCONNECT FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY
| (a) Remove the 2 clips and disconnect the front fender splash shield sub-assembly. |
|
2. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY
| (a) Remove the 4 clips. |
|
(b) Pull back the edge of the front fender splash shield sub-assembly and disengage the 5 claws by pushing the area indicated by the arrow in the illustration with a finger.
| Remove in this Direction (1) |
| Remove in this Direction (2) |
NOTICE:
(c) Disengage the 9 clips as shown in the illustration to remove the front fender moulding sub-assembly.
Removal
Wheel Opening Moulding(for Rear Side)Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Dynamic Radar Cruise Control System: Software Incompatibility with Body Control Module Not Programmed (U032251)
DESCRIPTION If the forward recognition camera cannot verify the vehicle information sent from the main body ECU (multiplex network body ECU), the forward recognition camera stores DTC U032251. DTC No. Detection Item DTC Detection Condition Trouble Area MIL DTC Output from U032251 ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Airbag System: Short in Side Squib (LH) Circuit (B1825-B1828)
DESCRIPTION The front side squib LH circuit consists of the airbag sensor assembly and front seat airbag assembly LH. The airbag sensor assembly uses this circuit to deploy the airbag when deployment conditions are met. These DTCs are stored when a malfunction is detected in the front side squib LH ...