DESCRIPTION
During self diagnosis of the parking assist ECU, the parking assist ECU sends display mode ID signals to the rear television camera assembly. This DTC is stored when the output of the rear television camera assembly does not match the expected output.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C2A6A | Back Camera Response Malfunction | Abnormal response from the rear television camera assembly |
|
CAUTION / NOTICE / HINT
NOTICE:
Click here
Click here
PROCEDURE
| 1. | CHECK FOR DTC |
(a) Clear the DTCs.
Chassis > Circumference Monitoring Camera Control Module > Clear DTCs(b) Check for DTCs.
Chassis > Circumference Monitoring Camera Control Module > Trouble CodesOK:
DTC C2A6A is not output.
| OK | | USE SIMULATION METHOD TO CHECK |
|
| 2. | REPLACE REAR TELEVISION CAMERA ASSEMBLY |
(a) Replace the rear television camera assembly with a new or normally functioning one.
Click here
|
| 3. | CHECK FOR DTC |
(a) Clear the DTCs.
Chassis > Circumference Monitoring Camera Control Module > Clear DTCs(b) Check for DTCs.
Chassis > Circumference Monitoring Camera Control Module > Trouble CodesOK:
DTC C2A6A is not output.
| OK | | END (REAR TELEVISION CAMERA ASSEMBLY WAS DEFECTIVE) |
| NG | | REPLACE PARKING ASSIST ECU |
Back Camera Internal Circuit (C2A63)
Side Camera LH Response Malfunction (C2A6B)Lexus RX (RX 350L, RX450h) 2016-2026 Owners Manual > Opening, closing and locking the doors: Side doors
The vehicle can be locked and unlocked using the entry function,
wireless
remote control or door lock switches.
Locking and unlocking the doors from the outside
Smart access system with push-button start
Carry the electronic key to enable this function.
Grip the driver's door handle to
...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Cylinder Head: Replacement
REPLACEMENT CAUTION / NOTICE / HINT HINT:
Use the same procedure for bank 1 and bank 2.
The following procedure is for bank 2.
PROCEDURE 1. REPLACE INTAKE VALVE GUIDE BUSH (a) Heat the cylinder head LH to between 80 and 100°C (176 and 212°F). (b) Place the cylinder head LH on wooden blocks ...