DESCRIPTION
During self diagnosis of the parking assist ECU, the parking assist ECU sends display mode ID signals to the side television camera assembly LH. This DTC is stored when the output of the side television camera assembly LH does not match the expected output.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C2A6B | Side Camera LH Response Malfunction | Abnormal response from the side television camera assembly LH |
|
CAUTION / NOTICE / HINT
NOTICE:
Click here
Click here
PROCEDURE
| 1. | CHECK FOR DTC |
(a) Clear the DTCs.
Chassis > Circumference Monitoring Camera Control Module > Clear DTCs(b) Check for DTCs.
Chassis > Circumference Monitoring Camera Control Module > Trouble CodesOK:
DTC C2A6B is not output.
| OK | | USE SIMULATION METHOD TO CHECK |
|
| 2. | REPLACE SIDE TELEVISION CAMERA ASSEMBLY LH |
(a) Replace the side television camera assembly LH with a new or normally functioning one.
Click here
|
| 3. | CHECK FOR DTC |
(a) Clear the DTCs.
Chassis > Circumference Monitoring Camera Control Module > Clear DTCs(b) Check for DTCs.
Chassis > Circumference Monitoring Camera Control Module > Trouble CodesOK:
DTC C2A6B is not output.
| OK | | END (SIDE TELEVISION CAMERA ASSEMBLY LH WAS DEFECTIVE) |
| NG | | REPLACE PARKING ASSIST ECU |
Back Camera Response Malfunction (C2A6A)
Side Camera RH Response Malfunction (C2A6C)Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Can Communication System: ECU Malfunction (B1003)
DESCRIPTION DTC No. Detection Item DTC Detection Condition Trouble Area Note B1003 ECU Malfunction The network gateway ECU detects an internal malfunction. Network gateway ECU - PROCEDURE 1. RECONFIRM DTC OUTPUT (a) Connect the Techstream to the DLC3. (b) Turn the ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Audio And Visual System (for 8 Inch Display): Lost Communication with Haptic Device (B1323-B1326)
DESCRIPTION These DTCs are stored when communication between the radio receiver assembly and remote touch (remote operation controller assembly), combination meter assembly, headup display (meter mirror sub-assembly)* or clock assembly is not possible.
*: w/ Headup Display System
DTC No. ...