DESCRIPTION
During self diagnosis of the parking assist ECU, the parking assist ECU sends display mode ID signals to the side television camera assembly RH. This DTC is stored when the output of the side television camera assembly RH does not match the expected output.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C2A6C | Side Camera RH Response Malfunction | Abnormal response from the side television camera assembly RH |
|
CAUTION / NOTICE / HINT
NOTICE:
Click here
Click here
PROCEDURE
| 1. | CHECK FOR DTC |
(a) Clear the DTCs.
Chassis > Circumference Monitoring Camera Control Module > Clear DTCs(b) Check for DTCs.
Chassis > Circumference Monitoring Camera Control Module > Trouble CodesOK:
DTC C2A6C is not output.
| OK | | USE SIMULATION METHOD TO CHECK |
|
| 2. | REPLACE SIDE TELEVISION CAMERA ASSEMBLY RH |
(a) Replace the side television camera assembly RH with a new or normally functioning one.
Click here
|
| 3. | CHECK FOR DTC |
(a) Clear the DTCs.
Chassis > Circumference Monitoring Camera Control Module > Clear DTCs(b) Check for DTCs.
Chassis > Circumference Monitoring Camera Control Module > Trouble CodesOK:
DTC C2A6C is not output.
| OK | | END (SIDE TELEVISION CAMERA ASSEMBLY RH WAS DEFECTIVE) |
| NG | | REPLACE PARKING ASSIST ECU |
Side Camera LH Response Malfunction (C2A6B)
Front Camera Response Malfunction (C2A6D)Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Headlight Cleaner Motor: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight cleaner motor and pump assembly removal/installation are shown below. Necessary Procedure Afte ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Headup Display System: Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. HINT: Using the Techstream to read the Data List allows the values or states of ...