General Maintenance
GENERAL MAINTENANCE
CAUTION / NOTICE / HINT
The owner can do them or they can have them done at a service center.
These items include those that should be checked on a daily basis, those that in most cases do not require special tools, and those that are considered to be reasonable for the owner to do.
General maintenance items and procedures are as follows:
PROCEDURE
1. GENERAL NOTES
2. TIRES
(a) Check the tire inflation pressure with a gauge. Make adjustments if necessary.
(b) Check the surfaces of the tires for cuts, damage or excessive wear.
3. WHEEL NUTS
(a) Check for nuts that are loose or missing. Tighten them if necessary.
4. TIRE ROTATION
(a) Check the maintenance schedule in the owner's manual.
5. WINDSHIELD WIPER BLADES
(a) Check the blades for wear or cracks whenever they are unable to wipe the windshield clean. Replace them if necessary.
6. FLUID LEAKS
(a) Check under the vehicle for leaking fuel, oil, water and other fluids.
NOTICE:
If you smell fuel or notice any leaks, locate the cause and correct it.
7. DOORS AND ENGINE HOOD
(a) Check that all of the doors and the hood operate smoothly, and that all of the latches lock securely.
(b) When the primary latch is released, check that the engine hood secondary latch prevents the hood from opening.
General Maintenance
Under HoodLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Seat Belt Warning System: How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT:
Use the following procedure to troubleshoot the seat belt warning system.
*: Use the Techstream.
PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP
NEXT 2. CUSTOMER PROBLEM ANALYSIS (a) Interview the customer to confirm the problem. Clic ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Valve Body Assembly: Inspection
INSPECTION PROCEDURE 1. INSPECT SHIFT SOLENOID VALVE S1 (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition Shift solenoid valve S1 connector terminal - Shift solenoid valve S1 body 20°C (68° ...