DESCRIPTION
If the ECM cannot recognize the forward recognition camera. DTC U040181 is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | DTC Output from |
|---|---|---|---|---|---|
| U040181 | Invalid Data Received from ECM/PCM "A" Invalid Serial Data Received | Approximately 17 seconds or more after the engine switch is turned on (IG), the ECM cannot recognize the forward recognition camera for approximately 2 seconds or more. | ECM | Does not come on | Radar Cruise2 |
CAUTION / NOTICE / HINT
NOTICE:
Before replacing the ECM, refer to Registration.
Click here
PROCEDURE
| 1. | CHECK FOR DTCs |
(a) Clear the DTCs.
Powertrain > Radar Cruise2 > Clear DTCs(b) Make sure that the DTC detection conditions are met.
HINT:
If the detection conditions are not met, the system cannot detect the malfunction.
(c) Check for DTCs.
Powertrain > Radar Cruise2 > Trouble Codes| Result | Proceed to |
|---|---|
| DTC U040181 is not output | A |
| DTC U040181 is output | B |
| A | | USE SIMULATION METHOD TO CHECK |
| B | | REPLACE ECM |
Software Incompatibility with Body Control Module Invalid/Incompatible Software Component (U032257)
Cruise Control Switch CircuitLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Airbag System: Curtain Shield Airbag Sensor (LH) (B1635,B1637)
DESCRIPTION The side collision sensor LH circuit (bus 1) consists of the airbag sensor assembly, door side airbag sensor LH and rear airbag sensor LH. The door side airbag sensor LH and rear airbag sensor LH detect impacts to the vehicle and send signals to the airbag sensor assembly to determine if ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Window Control System: Terminals Of Ecu
TERMINALS OF ECU CHECK MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY (a) Disconnect the N7 multiplex network master switch assembly connector. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the values on the wire harness side with the connector disconn ...